Rockwell Automation 20P PowerFlex DC Drive 115V AC to 24V DC I/O Converter Circuit Board - Manual

Installation Instructions
PowerFlex
®
DC Drive 115V AC to 24V DC I/O
Converter Circuit Board
What This Kit Includes
•
115V AC to 24V DC I/O Converter circuit board
•
Two stand-offs
•
Two spring washers
•
Two screws
What This Option Provides The 115V AC to 24V DC I/O Converter board allows you to convert 115V
AC digital input signals to 24V DC digital input signals to interface with the
standard digital I/O on the PowerFlex DC Drive Control board.
The card consists of:
•
Eight (8) opto isolated 115V AC digital inputs
•
Eight (8) interface outputs for the digital inputs on Control board of the
drive
•
Two (2) input terminals for the 24V DC power supply voltage
Tools That You Need
•
Phillips
®
screwdriver
•
Nut driver or wrench for hex stand-offs
Phillips
®
is a registered trademark of Phillips Screw Company.
!
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
!
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the
following.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.