Rockwell Automation 20P PowerFlex DC Drive Analog and Digital I/O Expansion Circuit Board - Manual

Installation Instructions
PowerFlex
®
DC Drive Analog and Digital I/O
Expansion Circuit Board
What This Kit Includes
•
I/O Expansion circuit board
•
Two stand-offs
•
Two spring washers
•
Two flat washers
•
Two screws with captive lock washers
What This Option Provides The I/O Expansion Card is a drive mounted board that provides these
additional I/O signals.
•
Four (4) Digital Inputs
•
Four (4) Digital Outputs
•
Two (2) Analog Outputs
Tools That You Need
•
Phillips
®
screwdriver
•
Nut driver or wrench for hex stand-offs
•
Flathead screwdriver
Phillips
®
is a registered trademark of Phillips Screw Company.
!
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
!
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the
following.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.