Rockwell Automation 20P PowerFlex DC Drive - Frame A Field Circuit Board - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame A Field Circuit
Board
What This Kit Includes
•
Field circuit board
•
Plug-in terminal block for Field connections
•
Two screws for Field circuit board
•
Two hexagonal stand-offs
•
Two screws for the hexagonal stand-offs
•
One plastic stand-off
•
Cables for connector X3 and XFCD
•
Flathead screwdriver for terminal block connections
•
Isolation sheet
•
Static strap
Important: It is highly recommended that the Field SCR/Dual Diode
Bridge module be replaced when replacing the Field circuit
board. The Field SCR/Dual Diode Bridge module is sold as a
separate spare part kit.
Tools That You Need
•
Phillips
®
screwdriver
•
Flathead screwdriver
•
Nut driver or wrench for hex stand-offs
Phillips
®
is a registered trademark of Phillips Screw Company.
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the
following.
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.