Yamato Scientific Hitech controller type Ⅳ - Manual (Page 8)

6
Fig. 2.2: Step Variation of Ramp Time
The soak time is set at zero (0) for a segment with only gradient-operation, while the
ramp time is set at zero (0) for a segment with only fixed-value operation. Figure 2.3
shows a connected pattern of these 2 segments. In this figure, Section (4) is a segment
only with the soak time set at zero (0).
Fig. 2.3: Connection of Segmen4
■ ■ ■ ■ Attribute Parameters of Segments
Attribute Parameters of Segments Attribute Parameters of Segments Attribute Parameters of Segments
In addition to the three basic parameters discussed above, you may preset the following
parameters.