Yamato Scientific Hitech controller type Ⅳ - Manual (Page 17)

15
[Setting a Repeat Command] [Setting a Repeat Command] [Setting a Repeat Command] [Setting a Repeat Command]
hey
Operation
Main
Display Sub Display Explanation
Approx. 1 second later
↓
↓
Push ▲ or
▼ key.
Push
ENTER
key. The main display shows that the
programmable controller is ready for
inputting Segment 4.
Push▲ or ▼ key to change the controller
to the input mode of Repeat Command. The
main display flashes (Repeat).
Requesting to input the number of Repeat
Start Segment .
↓
Lighting
↓ ↓
Push ▲ or
▼ key and
ENTER
key. Push ▲ or ▼ key to show the desired
repeat start segment number of 2 and push
ENTER key to accept it. The main display
changes from flashing to lighting.
(Repeat Count): Requesting to
input the repeat frequency. Default is set at
1.
↓
Push▲ or
▼ key and
ENTER
key.
Lighting
Push ▲or ▼ key to show a repeat frequency
of 2 and push ENTER key to accept it. The
main display changes from flashing to
lighting.
You have finished setting Repeat Command.. You have finished setting Repeat Command.. You have finished setting Repeat Command.. You have finished setting Repeat Command..
[Setting Segment 4]
[Setting Segment 4] [Setting Segment 4] [Setting Segment 4]
Key
Operation
Main
Display Sub
Display Explanation
Approx. 1 second later
↓ ↓
Push
ENTER
key. Activates Input mode for Segment 4 when
you accept the repeat command.
Requesting to input Ramp Time 4
of Segment 4.
Input and preset the following parameters in the same manner as previous segments.
: 0 minute (This is a segment of only the fixed value operation )
: 150℃
: 50 minutes
: ON
: 10
You have finished setting Segment 4. You have finished setting Segment 4. You have finished setting Segment 4. You have finished setting Segment 4.