Yamato Scientific Hitech controller type Ⅳ - Manual (Page 12)

10
Indication of the rest of the repeat count Indication of the rest of the repeat count Indication of the rest of the repeat count Indication of the rest of the repeat count
The rest of the repeat frequency including the ongoing segment can be shown on the
sub display by using the DISPLAY key while performing the repeat command of
the program operation.
[Operation Procedure] [Operation Procedure] [Operation Procedure] [Operation Procedure]
Key Operation Main Display Sub Display Explanation
The repeat operation is on : Ex. While performing the repeat operation the segment 2 to 3 of the
program 2
Push the Display
key several times It shows the present
measured
temperature
(Ex.: Indication of
the execution
segment)
Push the display key and
make the sub display shown
the execution segment.
The sub display shows the
ongoing program number at
the left double-digit and the
ongoing segment at the
right double-digit.
When performing this
operation while running the
repeat operation, the dot
point of the LSB (the right
most digit) flashes.
Push either ▲ key
or ▼ key It shows the present
measured
temperature
(Ex.: Indication of
the execution
segment)
↑↓
Shown
alternately
(Ex.: Indication of
the remaining repeat
frequency)
The remaining repeat
frequency can be shown on
the sub display by pushing
the ▲ key or ▼key while the
dot point located at the
corner of the below to the
right of the segment number
is flashing ( during running
the repeat operation.)
The remaining repeat
frequency shown at this
time includes the ongoing
segment.
When you perform the
repeat operation infinitely
(the setting of the repeat
frequency is 0), 0 is shown
on the sub display.