Yamato Scientific Hitech controller type Ⅳ - Manual (Page 23)

21
3. INPUTTNG AND SETTING FUNCTIONS
You can add a variety of functions by using MODE key. This section discusses the
inputting and setting functions, which are common to all Yamato Scientific's machinery
and equipment. For setting the functions particular to your system, see the operating
instructions of the system. If your system does not support certain functions, pushing
MODE key simply skips those functions, which are not shown on the displays.
3.1 Switching between Time and Period
Starting time of the automatic state operation and the program operation, and ending
time of automatic stop operation can be designated by either time or period-of
operation, If you set them by time, the sub display shows it at the upper left corner.
In this paragraph, you will learn how to change the setting from time to period of
operation.
[Procedure] [Procedure] [Procedure] [Procedure]
Key
Operation
Main
Display Sub
Display Explanation
Push the
MODE key
and then
push either
▲key or ▼
key Push MODE key several times to
show (Time) on the main
display, The sub display shows the present
time.
(Lighting)
Approx. l second later
Push ENTER
key. Activates Time/Period Switching mode.
↑
↓
Alternate
indication
Push ▲ or ▼
key.
:Time (XX o'clock XX minutes)
:Interval (E hours XX minutes
or XXX hours)
Push ▲ or ▼ key to show on
the main display.