Yamato Scientific RE510 Evaporators, Rotary - Manual (Page 17)

15
Installation/Assembly
RE510
13. Connecting the cooling condenser holder shaft (glass set B & C only)
Fit the cooling condenser holder shaft firmly into the screw hole on the back of motor. Put the
attached hexagon wrench through the hole on the end of shaft, and fasten tightly.
14. Connecting the cooling condenser and condenser holder
(B & C condenser only)
1. Connect the cooling condenser to the condenser connector. Attach by the cooling condenser
clamp.
2. Insert the cooling condenser holder from the top of condenser, while fitting the other side
through the holder shaft. (For type C, be sure to insert the cooling condenser holder from the
bottom of condenser rather than top and connect to the condenser connector )
3. Fit the suction cock to type B or the cooling condenser lid to type C.
Cooling Condenser Clamp Cooling Condenser Holder
Suction Cock Condenser Lid