Yamato Scientific RE510 Evaporators, Rotary - Manual (Page 15)

13
Installation/Assembly
RE210 and RE510
9. Set the cooling condenser nut, coil ring and vacuum seal to the condenser
or condenser connector.
1.Remove the cooling condenser nut on the left
side of the motor.
2.Connect the cooling condenser nut and then
coil ring to the condenser or condenser
connector (which ever applies).
3.Insert the vacuum seal to the condenser or
condenser connector (which ever applies).
* It is optional to put grease on the vacuum seal.
Glass Type A Glass Type B/C
10. Connect cooling condenser or condenser connector to the motor.
Insert the steam duct into vacuum seal, put glass flange to the motor and fasten firmly the cooling
condenser nut.
Be careful not to damage the vacuum seal when inserting the steam duct.
Glass Type A
Glass Type B/C
● ● ● ●Removing the coil ring from cooling condenser or condenser connector
Hook the coil ring by the attached hexagon wrench as shown in the left
picture in order to remove the ring easily from the cooling condenser or
condenser connector.
Apply moderate force to remove the coil ring ; extreme force may damage
the coil ring and or the glass apparatus.
Coil Ring
Vacuum Seal
Coil Ring
Vacuum Seal