Yamato Scientific RE510 Evaporators, Rotary - Manual (Page 12)

10
Installation/Assembly
RE210
4. Attach the motor to the motor support clamp.
1. Fit the motor bearing bar to the motor support clamp, and fasten the clamping screw tightly.
Put D-cut surface ( flat surface ) of the bar perpendicularly to the screw.
2. Slant the motor to the right (about 45 °) and finger tightly the motor screw.
If you do not fasten the screws tightly,
vibration may occur preventing accurate
measurements or the motor may fall causing
the glass apparatus to break.
5. Attach the controller to the support rod.
Attach the controller to the support rod by attached clamping screw.
Bearing bar
Motor Support Clamp
Clamping Screw
Controller
Motor Screw