WINGITS PREMIUM Grab Bar WGB5PSxx - Manual

Technical Data Sheet
Toll Free: 877-894-6448 • www.wingits.com • [email protected]
20140822_rev3
WGB5
Stainless Steel Grab Bar
PREMIUM
™
Width: See product part number for width. Complete length of Grab Bar is usable surface.
Diameter: 1.25” (3.2cm)
Entire product is stainless steel.
W ING I TS ®
PREMIUM ™ Structural Stainless Steel Grab Bars are designed to hold live loads and
must be installed into adequate structural blocking or with W ING I TS ®
Grab Bar Fasteners
Use: Wall Installation.
Load Capability: 800 lbs (362.9kg)
W ING I TS ® PREMIUM ™ Structural Stainless Steel Grab Bars meet or exceed the
applicable requirements of all building codes, ADA criteria, and 2010 ADAAG and
2009 ANSI standards.
For hollow wall construction, it is recommended that W ING I TS ®
Grab Bar Fasteners
are used with this product. See Fastener instructions for applications.
MECHANICAL DATA
PRODUCT COMPOSITION
MODALITY
INSTALLATION
CERTIFICATIONS
RECOMMENDED INTEGRATION
Model:
Part Numbers:
WGB5PS12 WGB5SS12
12” Polished Finish
WGB5PS16
16” Polished Finish
WGB5PS18
18” Polished Finish
WGB5PS24
24” Polished Finish
WGB5PS30
30” Polished Finish
WGB5PS32
32” Polished Finish
WGB5PS36
36” Polished Finish
WGB5PS42
42” Polished Finish
WGB5PS48
48” Polished Finish
12” Satin Finish
WGB5SS16
16” Satin Finish
WGB5SS18
18” Satin Finish
WGB5SS24
24” Satin Finish
WGB5SS30
30” Satin Finish
WGB5SS32
32” Satin Finish
WGB5SS36
36” Satin Finish
WGB5SS42
42” Satin Finish
WGB5SS48
48” Satin Finish
• All parts are Stainless Steel - tubing is 18-gauge (1.2mm)
• Mounting Flanges are 3”(75mm) in diameter, 3/32”(2.5mm) thick, HeliArc
welded to the tubing. Mounting Flanges have 5 holes for attachment to WINGITS
or adequate blocking.
• Snap-On Flange Covers are 22 gauge (0.8mm) drawn stainless steel, 3”(76mm)
in diameter and 3/8”(10mm) in height.
• Provide 1-1/2”(38mm) clearance from wall.