WINGITS Grab Bar RESGBW35 - Manual (Page 2)

NOTE: For Maximum Safety and to meet ADA Requirements, Grab Bars should be Installed Horizontally 33-36” from the floor.
Before You Install:
• Verify the length of the grab bar by measuring from the inside of one flange to the outside of the other.
• To ensure adequate clearance, a stud finder should be used to verify there are no studs within the area
where the WINGITS
® will be installed.
Make sure that there is at least 1.5” away from the edge of the stud. If concerned, drill a pilot hole and insert a piece of wire in
the shape of an “L” - twirl the wire to make sure there is nothing in the way.
• Clean wall surface
Installation Holes
Face Plate
Screw
3M®
Waterproof
Tape/Liner
Wings
Wings
Screw
W
ING
I
TS ®
Installation Instructions
RESGBW35
NEVER INSTALL ANY FASTENER INTO WET OR DETERIORATING WALLS Structural Blocking Must Be Used In PLAIN 1/2” DRYWALL
When Attempting To Meet Commercial Building Codes.
Commercial Grab Bar Fastening System Installation Guide. WINGITS ® Grab Bar Fastening Systems
Exceed Building Codes For Grab Bars In The Following Wall Substrates:
• 5/8” Drywall - Painted or Wallpapered
• 1/2” or 5/8” Drywall with Tub Surrounds
• 1/2” or 5/8” Drywall with Tile, Marble or Stone
• 1/2” or 5/8” Drywall with any Panel Types including Fiberglass, Faux Marble, Acrylic and Plastics
• Multiple Layers of Drywall, Plaster and Lathe
• 1/4” Acrylic/Fiberglass Tub Surrounds
• Most Wall Panels, All Masonary Type Boards, with or without Decorative Panels
View Installation Videos at:
www.wingits.com
INSTALLATION INSTRUCTIONS
6. Compress and insert the WINGS
into the drilled hole.
7. WINGS should be flush with the
wall surface.
8. Pop WINGITS ® through the hole
by pushing on the FACE PLATE.
9. Using the enclosed 3.5”
STAINLESS STEEL SCREWS,
attach the object to the WINGITS ®.
NOTE:
Strength and stability are greatly affected by
projection off the wall surface and the length
of interaction with the wall surface. Call us at
877.894.6448 for guidance. WINGITS
® are
designed to be used in vertical walls only.
DO NOT USE IN CEILINGS.
1. PEEL the 1/4” liner (scored)
off the tape and fold up until
properly placed. 2. Determine location of Grab Bar and mark
length on the wall, remove center hole,
then place tape with the center hole over
mark. Stick tape to the wall remove the remaining liner.
3. Use the tape as a template,
Drill out two 3/4” holes. 4. Once holes are drilled remove tape liner.
5. Insert the WINGS into the FACEPLATE
(the tubes interlock). Extend the WINGITS
® to full length.
Grab Bar installed with RESGBW35 WINGITS ®
FACEPLATE WINGS