beautypg.com

Modern elegance, Wingits, Installation instructions – WINGITS Grab Bar GBWME40 User Manual

Page 2: Gbwme40

background image

W

ING

I

TS

®

Installation Instructions

View Installation Videos at:

www.wingits.com

W12-02122013

MODERN Elegance™ Installation Guide Specifications

Mounting of the Stand-Off Screws MUST be installed into adequate structural blocking.

DESCRIPTION

INCLUDED

OPTIONAL

Grab Bars

2.5’’ s/s screws

GBWME40

Towel Bars (all)

1-5/8’’ s/s screws

MAWME35 (WINGITS)

Robe Hooks (all)

1-5/8’’ s/s screws

MAWME35 (WINGITS)

Toilet Paper Holder
Vertical

2’’ s/s screw

MAWSD35 (WINGITS)

Single

1-5/8’’’ s/s screws

MAWME35 (WINGITS)

Vertical Towel Racks*

MAWME35 (WINGITS) 1-5/8’’’ s/s screws

SPIRE Towel Vine*

MAWME35 (WINGITS) 1-5/8’’’ s/s screws

SCOOP Towel Vine*

MAWME35 (WINGITS) 2’’ s/s screws

WAVE Foot Rest*

MAWSD35 (WINGITS) 2.5’’ s/s screws

Bariatric Grab Bars

2.5’’ s/s screws

GBW40

MODERN Elegance

WINGITS

®

MODERN Elegance™ Grab Bar Fastening System Installation Guide

W

ING

I

TS

®

Grab Bar Fastening Systems

Exceeds Building Codes For Grab Bars In The Following Wall Substrates:

GBWME40

SCREW

1. Drill 1.25” hole on the marks by the INDICATOR POINTS.
2.
Peel one side off of waterproof tape and adhere around drilled hole in wall.
3. Remove center SCREW completely.
4. Insert SCREW through STAND-OFF and rethread into fastener.
5. Insert the WingIts™ into the wall.
6. Push the SCREW head all the way into the STAND-OFF until the wings “POP” behind the wall.
7. Pull on STAND-OFF, remove tape liner - keep STAND-OFF away from wall as you tighten.
8. Attach Grab Bar and tighten set screws.

WINGS

STAND-OFF

INDICATOR POINT

FLAT FOR SCREW

MODERN Elegance

uses Indicator Points to simplify installation.

1. Remove the stand-offs to expose the INDICATOR POINTS on the accessory.
2. To ensure adequate clearance, a stud finder should be used to verify there are no studs within the area where the WingIts™ will be installed.
Make sure that there is at least 1.5” away from the edge of the stud.
3. Place the accessory in the preferred location and push on the accessory to mark the points where stand-offs will be mounted.

• 5/8” drywall - painted or wallpapered
• 1/2” or 5/8” drywall with tub surrounds
• 1/2” or 5/8” drywall with tile, marble or stone
• 1/2” or 5/8” drywall with any panel types including
fiberglass, faux marble, acrylic and plastics
• Multiple layers of drywall
• Plaster and lathe
• 1/4” acrylic / fiberglass tub surrounds
• Most wall panels, all masonary type boards, with or without decorative panels

GBWME40

Installing MODERN Elegance™ Grab Bars

Bradley Beach, NJ USA • Toll Free: 877-894-6448
www.wingits.com • [email protected]