Vicor PFC Micro Power Factor Corrected AC-DC Switcher - Manual (Page 16)

PFC Micro Design Guide
Specifications (Typical at 25°C, nominal line and 75% load, unless otherwise specified)
G ENERAL
Number of Outputs 1-6
Modules VI/E-200 and VI/E-J00: Two VI/E-200s or Four V/EI-J00s
Maxi: Two Maxis, Four Minis or Six Micros
Efficiency Typically > 75%
Safety Agency Approvals cURus – UL 60950-1, CSA 60950-1;
cTUVus – EN 60950-1, UL 60950-1, CSA 60950-1
CE Mark – Low Voltage Directive, 2006/95/EC
Note: certain wide temp range MI chassis will not carry all approvals
Maximum Output Power 500W at 115Vac, (100 Vac minimum input)+
800W at 230Vac, (200 Vac minimum input)
+ Note; Not to exceed an input current of 7.5A.
I NPUT
Input 85-264 Vac, 47-500Hz
120-300 Vdc (derated output level)
VI-200/VI-J00 Line/Load Regulation 0.2% max. from 10% to full load
0.5% max. from no load to 10% load
Maxi/Mini/Micro Line Regulation* 0.20% max to 0.30%max
Maxi/Mini/Micro Load Regulation* 0.20% max to 0.70% max
Inrush Current 8.5A peak @ 115 Vac
17A peak @ 230 Vac
Ride Through Time >20 ms at 500W load (nominal load)
Conducted EMI FCC Class A
EN 55022 Class A (consult factory)
Mil-STD 461 requires external filter
Power Factor >.98
Transient Burst Immunity EN61000-4-4 (consult factory)
Surge Immunity Compliant with IEC 61000-4-5, Level 3, Performance Criteria B
(Common Mode & Normal Mode) (Temporary loss of output power may occur which is self recoverable.)
Dielectric Withstand Primary to Chassis GND = 2,121 Vdc
Secondary to Chassis GND = 750 Vdc
MI Chassis Overvoltage and Transients Compliant to Mil-STD 704 and 1399
* See Vicor module specifications. A preload may be necessary for modules trimmed down below 90% of normal
output voltage.
Pg. 16 Vicor 800-735-6200 Westcor Division 408-522-5280 Applications Engineering 800-927-9474 03-000048 rev A