UVP VisiDoc-It Imaging System - Manual (Page 8)

VisiDoc-It Imaging System 8
Using the System
Powering Up the System

Power up the system by pushing once on the MAIN
POWER button located on the right side of the
processor.

Turn on the transilluminator.

To power down the system, push the main power
button.
Adjusting the Screen Angle

To adjust the angle of the screen, loosen the
knobs on each side of the monitor. Twist each
knob counter-clockwise.

Tilt the screen to the desired angle.

Turn each knob clockwise to tighten .
Operating the TS Software
The system will go through the boot-up process. When ready, the LCD will display the TS software screen
similar to the one below:
Main power