Titus TMR / TMRA IOM - Manual (Page 3)

3 Installation Manual - TMR/TMRA Redefine your comfort zone. ™ | www.titus-hvac.com
TMR/TMRA IOM
Adjusting Inner Cone Position (TMRA) only)
Type 1 Inner Cone:
The type 1 inner cone assembly has three fixed cone positions. The cone position is adjusted by remov-
ing the cone assembly and repositioning it.
To reposition the inner cone assembly, remove the positioning screws and align the screw hole with the
new position desired. Insert and tighten the screws in the new position.
Type 2 Inner Cone: (Steel only, sizes 6”-12”)
The type 2 inner cone assembly is adjusted by sliding the inner cones up or down as desired.
To reposition the cones loosen the positioning screws and slide the cones to the new position. Tighten
the screws to secure cones in place.
Type 3 Inner Cone: (Steel only)
The type 3 inner cone assembly is adjusted by rotating the center cone.
To reposition the cones, rotate the center cone clockwise or counter clockwise to raise or lower the
cones.
Type 1: 3 Fixed Positions
Type 2: Sliding
Type 3: Rotating