Titus T3SQ-2 Commissioning Guide - Manual (Page 2)

Commissioning Guide - T3SQ-2
2
C O M M I S S I O N I N G G U I D E
T3SQ-2
Update Software
Follow the guidelines set by the wiring diagram on the
back for every diffuser and on the power-pack. Connect
max 7 diffusers in series using the slave cables to the
right-hand port on the power pack and then connect
8 diffusers max in series to the left-hand port on the
power pack. Any one of these diffusers can be Drone
or Masters.
Connect a USB set-up module to the centre port on
the power pack for commissioning purposes. A Master
Communications module can also be connected to this
port for continuous monitoring and commissioning via
an Ethernet network.
LOG THE UNIQUE ADDRESS for each diffuser (hanging
from a tag below the diffuser and duplicated on the
black box on the tile of the diffuser) onto the layout
drawing. This will facilitate easy commissioning.
Plug the USB module into you PC and open the Titus
BACS software tool. Make use of the MLM software
quick start guide if you need help.
In the Software Tool Bacs screen click on File and then
Update Flash.
Choose Type analog[8] and browse for the MLM_
analog_load_v1.05.txt file.
Press LOAD and then UPDATE
Choose Type interface[10] and browse for the MLM_
interface_load_v1.20.txt file.
Press LOAD and then UPDATE. Press CANCEL when
finished