Control start-up, operation, Calibration instructions, Replacement parts – Titus Single Duct Terminal IOM User Manual
Page 2
SD-IOM-2.0
6-15-02
Field Wiring
All field wiring must comply with the local codes and
with the National Electrical Code (ANSI/NFPA 70-1981).
Electrical, control and piping diagrams are shown on the
exterior labeling or on the diagram on the inside of
control enclosure cover. All electric heaters if provided
by TITUS are balanced by kW per stage. The installing
electrician should rotate these heater stages by phase
in order to help balance the building electric load.
Control Start-up, Operation
Detailed information regarding power, accessory and
communications connections, start-up and operating
procedures for the controls provided by TITUS are
available from your local TITUS representative. For
specific information on controls by other manufacturers,
contact that manufacturer’s local branch or dealer.
Important: Units with digital controllers may incorporate
specific communication addresses based on Building
Management Systems Architecture, and original
engineering drawings. Installing the terminal in a
different location than noted on unit label may result in
excessive start-up labor.
Calibration Instructions
For Pneumatic Controls, see PNEU-IOM: Operations
Manual for Pneumatic Controls.
For Analog Controls: Titus TA1, see ANA-IOM: Analog
Controller Calibration.
For Digital Controls: see control manufacturer's manual
Replacement Parts
Description
Part Number
Primary Damper Assembly
Size 4-5-6"
31171301
Size 7"
31171302
Size 8"
31171303
Size 9"
31171304
Size 10"
31171305
Size 12"
31171306
Size 14"
31171307
Size 16"
31171308
Damper Shaft Extension
Short Stub all sizes
70300301
Long Ext. Sz. 4-6, 14, 16
70300302
Long Ext. Sz. 7-12
70300303
Shaft Bearing - All
70324901
Control Tube
Red Stripe 1/4" O.D.
61510035
Green Stripe 1/4" O.D.
61510234
Red Stripe 3/8" O.D.
61510279
Green Stripe 3/8" O.D.
61510280
Yellow Stripe 1/4" O.D.
61510260
White Stripe 1/4" O.D.
61510261
Blue Stripe 1/4" O.D.
61510262
Tees for sensor taps
Plastic 1/4"
42150011
Plastic 3/8"
42150020
Plugs for tees
1/4"
42160081
3/8"
10015601
AeroCross
TM
Multipoint Velocity Sensors
Size 4"
3151520001
Size 5"
3151520001
Size 6"
3151520002
Size 7"
3151520003
Size 8"
3151520004
Size 9"
3151520005
Size 10"
3151520006
Size 12"
3151520007
Size 14"
3151520008
Size 16"
3151520009
Size 24" x 16"
3151520009