Regency Bellavista B36XT Medium Gas Fireplace - Manual (Page 45)

Regency Bellavista™ B36XT Gas Fireplace
45
INSTALLATION
LOG SET INSTALLATION
Installation of Optional Panels must be completed before installing the log set.
Read the instructions below carefully and refer to the images. If the
logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can
alter the unit's performance which is not covered under warranty.
Log Kit #576-930 contains the following pieces:
A Right Front Log
B Left Front Log
C Top Middle Log
D Top Right Log
E Rear Log
902-156 Lava Rocks
902-179 Vermiculite
946-669 Platinum Embers
(supplied w/packaged manual)
1) Carefully remove the logs from the packaging and unwrap them. The
logs are fragile, handle with care - do not force into position.
2) Spread vermiculite along the base of the fi rebox.
Vermiculite
D
E
A
C
B
4) Place Log B on the front left side of the burner. Position the notch
on the bottom left side of the log into the left side of the grate.
Slide Log B back towards Log E until the fl at surface on Log B rests
up against the tabs on the burner and grate - this maintains a
necessary gap between Logs B & E.
3) Place Log E on the rear log support pins with the fl at side to the
back.
E
Notch
Tabs on
burner &
grate
B
Note: See fi nal positioning of Log B on next page.