Regency Plateau PTO30IST Outdoor Gas Firetable - Manual (Page 31)

Regency Plateau ® Series Outdoor Gas Fireplace
31 31
INSTALLATION OPERATING INSTRUCTIONS
FIRST FIRE
The fi rst fi re in your decorative gas appliance is part
of the paint curing process. To ensure that the paint
is properly cured, it is recommended that you burn
your decorative gas appliance for at least one (1)
hour the fi rst time you use it.
When fi rst operated, the unit will release an odour
caused by the curing of the paint, the burning off of
any oils remaining from manufacturing.
The glass surround may require cleaning after the
unit has cooled down.
DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS HOT.
OPERATING
INSTRUCTIONS
1) Read and understand these instructions before
operating this appliance.
2) Check to see that all wiring is correct and
enclosed to prevent possible shock.
3) Check to ensure there are no gas leaks.
4) Verify log placement. If the pilot cannot be
seen when lighting the unit, the logs have been
incorrectly positioned.
5) The unit should never be turned off, and on
again without a minimum of a 60 second wait.
LIGHTING PROCEDURE
1) Turn on ON/OFF switch.
2) After approximately 4 seconds the spark igni-
tion system will spark for 60 seconds to light
the main burner.
3) The unit will turn on.
Note: The fi rst try for ignition will last approximately
60 seconds. If there is no fl ame ignition (rectifi -
cation) the board will stop sparking for approxi-
mately 35 seconds. After wait time , the board
will start second try for ignition by sparking for
approximately 60 seconds . If there is still no
positive ignition the board will go into lock out.
The system will need to be reset as follows:
a) Turn the system off using ON/OFF switch.
b) After approximately 2 seconds turn on ON/
OFF switch.
c) Unit will repeat step 2.
SHUTDOWN
PROCEDURE
1) Turn ON/OFF switch.
2) If service is to be performed - you must discon-
nect the battery pack.