Regency Plateau PTO30IST Outdoor Gas Firetable - Manual (Page 19)

Regency Plateau ® Series Outdoor Gas Fireplace
19
INSTALLATION
LP TANK REMOVAL
LP TANK INSTALLATION
PTO30IST/PTO30CKT ONLY
2) Ensure tank is fully closed. Disconnect gas line.
3) Slide out LP gas tank by pulling from handle on slide out tray.
NOTE: DO NOT SLIDE OUT TANK BY GRASPING FROM TOP OF TANK.
4) Undo butterfl y bolt to release tank.
5) Refi ll tank and reinstall by reversing steps.
Butterfl y bolt
Butterfl y bolt
Slide out handle
1) Remove end panel (opposite end of switch panel).
1) Remove end panel (opposite end of switch panel).
2) Slide out LP gas tank by pulling from handle on slide out tray.
3) Undo butterfl y bolt to allow LP tank to be seated on the holder.
4) Place LP tank onto slide out try and screw in butterfl y bolt to secure
tank.
5) Push tank in from the bottom.
DO NOT PUSH IN FROM THE TOP OF THE TANK.
6) Connect the LP regulator quick connect to the tank
7) Check all gas connections (both valve train & propane tank) under nor-
mal operating pressure, for leaks, with soapy water.
NOTE: If soap bubbles, this would indicate a gas leak.
919-031
WARNING!
When using a LP tank - a minimum 1”(25mm) gap
at all times, between the floor and base of unit.
(Refer to owners manual)
must be maintained
Gas connection
@ tank
NOTE: Max tank size 20lb.