Regency Plateau PTO30IST Outdoor Gas Firetable - Manual (Page 14)

14
Regency Plateau ® Series Outdoor Gas Fireplace
INSTALLATION
CASTER INSTALLATION
Nutsert
Allen key
2. Line up mounting plate at each corner on bottom of unit.
Secure with three self tapping screws in locations shown below. 4. Retrofi t - Thread bolt into nutsert, hand tighten and fi nish tightening
bolt with supplied allen key.
If not a retrofi t install, position caster through hole - secure
caster with lock washer and lock nut.
5. After installation, lock out all 4 casters before assembling unit.
Caster location retrofi t and new
Screw locations
Screw location
Caster location (retrofi t) - Use Nutsert
Caster location (new) - Use bolt / lock washer / nut
Screw locations
Screw location
1. Install mounting plates onto bottom of Coffee Table or Island Plateau unit.
Use diagrams below to determine orientation of the plates and locations for screws and casters.
Note: there are different caster locations for the Island unit depending on whether the casters are being retrofi tted or not.
Coffee Table mounting plate confi gurations
IslandTable mounting plate
confi gurations
3. Line up caster with existing nutsert (retrofi t) or corresponding
hole ( see above diagrams) on plate.
Bottom of Plateau Unit Bottom of Island Unit
NOTE: Casters to be installed to the bottom of the unit frame before the unit is assembled.
Remove side and end panels - place on a soft clean surface.