Regency Hampton H35 Large Gas Stove - Manual (Page 35)

Hampton® H35-2 Direct Vent Freestanding Gas Stove
35
INSTALLATION
LOG SET
INSTALLATION
Read the instructions below carefully and refer
to the diagrams. If logs are broken do not use
the unit until they are replaced. Broken logs
can interfere with the pilot operation.
The gas log kit contains the following:
a) 02-43 Rear Log
b) 02-56 Middle Left Log
c) 02-44 Front Left Log
d) 02-46 Left
Top Log
e) 02-45 Front Right Log
f) 02-47 Center
Log
g) 02-48 Middle Right Log
h) Embers
i) Lava
j)
Platinum Embers (supplied with
packaged manual)
The "02" refer numbers (i.e. 02-43) are
molded into the rear of each log.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Lift off the Cast Top and remove the glass front
(refer to the "Glass Replacement" section in
this manual).
3) Sprinkle the embers on the left and right sides
of the fi rebox base.
A) 02-43 D) 02-46 G) 02-48
C) 02-44 B) 02-56 F) 02-47 E) 02-45
12) Adjust Vent restrictor setting: To set the Vent
restriction as indicated in the diagram, simply
loosen the screws and push the vent restrictor
plate to the correct position. Tighten the screws.
Vent Restrictor setting at Low Btu
for Straight Horizontal Venting
13) Attach the label "This unit has been converted
to..." on top of the Serial # decal over the higher
Btu information.
14) Check for gas leaks.
15) Check inlet and outlet pressures.
16) Check operation of fl ame control. Check for
proper fl ame appearance and glow on logs.
OPTIONAL
BRICK PANEL
1) Remove the cast top and glass front (see Glass
Replacement section in this manual for instruc-
tions).
2) Remove the log set if installed.
3) Insert the back brick panel fi rst by carefully
slipping it between the back wall of the fi rebox
and the rear log bracket.
Back Panel
Diagram 1
4) Before installing the side brick panels, loosen
the screws for the brick tabs enough so that you
can slide the brick tabs on to the screws easily
but that the tabs are secure. For the location
of the side brick tab screws see Diagram 1.
5) Put the side panels in next. Slide them in from
Brick
tab screw
Back
brick
panel
Side
brick
panel
Diagram 2
the front and push them fl at up against the
wall. Be very careful not to scratch them on
the fi rebox hardware.
Left
Side
Panel
Right
Side
Panel
Brick Tab
Screw
Brick
Tab
6) Install the brick tabs (refer to Diagram 2).
Embers Embers
Unit Btu/h Restrictor Opening
H35 - NG2 30,000 A 1-3/4" (45mm)
H35 - LP2 28,500 A 1-3/4" (45mm)