Regency Excalibur EX-E33 Large Gas Insert - Manual (Page 21)

E33 FPI Direct Vent Gas Insert
21
INSTALLATION
CONTEMPORARY FACEPLATE &
DOOR FRAME
1) Bring the faceplate up in front of the unit and connect the red & black
ON/OFF wires from the unit to the ON/OFF switch on the back of the
left side of the faceplate.
2) Connect the grey coated female ends of the black & red fan wires
from the unit to the male ends of the fan rheostat on the left side of
the faceplate as shown.
Fan Rheostat
3) Secure loose wires using wire clips along the back of the left side
of the faceplate. Ensure to run the wires away from the fi rebox as
much as possible.
4) Align the faceplate tabs with the tab brackets on the inside top of the
fi rebox and slide in place.
NOTE: For easy installation do not force both tabs in at the same
time, stagger from left to right.
Faceplate
Tabs
Kit# 341-914 Contents List:
1 Complete Faceplate with Switches
1 Door Frame
1 Bottom Louver
2 Hinges
4 Hinge
Screws
4 Hinge Spacers
8 Pan Head Screws
1 Wire Clip
1 Instruction Sheet Tab Brackets