Regency Bellavista B41XTE Large Gas Fireplace - Manual (Page 50)

50
Regency Bellavista™ B41XT Gas Fireplace
INSTALLATION
FLUSH GLASS DOOR INSTALLATION
Finishing
Trim Top
Finishing
Trim Side
NOTE: Install the Finishing Trim prior to installing the Flush Louvers.
1) Install the Finishing Trim sides as shown in the diagram; line up the holes in the
side trim with the holes in the fi rebox side.
2) Secure with 2 screws per side.
3) Loosen the 2 screws in the top inside edge of the fi rebox.
4) Slide the Finishing Trim Top over the Side Trim pieces and fi t the
bottom bracket slots over the screws. Tighten the 2 screws to
secure in place.
Finishing Trim Edge of Unit
B41XT B36XT
W 43-3/8" 40-1/2"
H 37-5/8" 35-3/4"
OPTIONAL FINISHING TRIM INSTALLATION
Diagram 3
Use the hook to pull the spring out until you can put the hook into the
slot on the bottom door bracket. Repeat for 2nd spring. See Diagram 3.
Diagram 2
The standard fl ush door comes with a black frame. To install the frame,
simply hook the top door fl ange onto the top of the unit and swing the
door towards the unit, see Diagram 1. Be careful that the glass gasket does not roll up; there must be a gap
between the gasket and the door lip to ensure that the door sits securely
on the unit, see Diagram 2.
Diagram 1
To remove the fl ush door, reverse the above steps.