Regency Bellavista B41XTE Large Gas Fireplace - Manual (Page 14)

14
Regency Bellavista™ B41XT Gas Fireplace
INSTALLATION
FINISHING
Non-combustible
Material
J-style Trim
or metal corner bead
may be used to finish these
edges
Non-combustible
Material
Non-combustible
Material
Diagram 2
Diagram 1
IMPORTANT FINISHING DETAIL NOTE:
Before placing unit into fi nal position - it is important to know the total thick-
ness / height of fi nished hearth (tile, carpet, etc.) The base of the fi replace
should be level or higher than the fi nished hearth height.
Diagram 3: Shown with optional Finishing Trim
Finishing material -
thicker than 1-1/4"
Important:
Finishing materials such as tile, river rock, etc, must not protrude beyond
the front facing fl anges the sides and top of the fi rebox opening.
Full Screen Doors Only:
If fi nishing with any material thicker than 1-1/4" - a 3/4" gap must be
maintained between the full screen doors and the fi nishing material.
This gap is necessary to facilitate the installation and removal of the full
screen doors.
Note:
All non-combustible facing material should butt up cleanly to the
fl anges around the fi rebox opening.
Rough edges will be visible from the front view with the fl ush louvers
or fl ush panels - if not using the optional fi nishing trim.
To maintain a clean fi nished edge - it is recommended to install the
non-combustible facing material with the fi nished edge against the
fi replace / nailing strips.
Alternatively, you can use J Style Trim or Metal Corner Bead to cover
cut edges of the non-combustible facing material.
Diagram 5
Diagram 4
Full Screen
Door
3/4"
43 3
8
"
37
5 8
"