Regency Bellavista B41XTE Large Gas Fireplace - Manual (Page 36)

36
Regency Bellavista™ B41XT Gas Fireplace
INSTALLATION
OPTIONAL STAINLESS STEEL / BLACK ENAMEL
PANEL INSTALLATION
LEFT
BACK
TOP
RIGHT
Note: Panels must be installed prior to the installation of the log set and vermiculite.
Before installation, panels must be handled and cleaned as per instructions noted below:
Stainless Steel Panels Black Enamel Panels
• Stainless panels must be inspected for scratches and dimples prior
to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration. • Black Enamel panels must be inspected for scratches and dimples
prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
• To protect the fi nish during installation and handling - cotton gloves
MUST be worn at all times while handling the panels (even when
removing protective coating).
•Stainless panels will discolor a little during normal operation.
This is normal and should not be considered a defect. • Black Enamel panels will discolor a little during normal operation. This
is normal and should not be considered a defect.
* All hand and fi nger marks MUST be cleaned off with a soft cloth and
a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner
(ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stains on panels which you
will be unable to remove. Not protected by product warranty.
* All hand and fi nger marks MUST be cleaned off with a soft cloth. Use
an ammonia based cleaner (ie. glass cleaner) to remove any fi ngerprints
before applying heat to the unit.
Failure to do this will result in burn stains on panels which you
will be unable to remove. Not protected by product warranty.
1) Prior to installation of the refl ective panels, remove the top panel
bracket currently fi tted into the baffl e opening on the inside top of
the fi rebox. See diagram below.
Top Panel Bracket
2) Install the back stainless panel fi rst - be careful not to scratch the
panel on the burner or log tray when installing. Ensure the back
panel is centered when installed.
3) Install the right side panel - secure with panel clip and 1 screw.
See step 3.
Back Panel
Right Side Panel