Regency Bellavista B41XTE Large Gas Fireplace - Manual (Page 38)

38
Regency Bellavista™ B41XT Gas Fireplace
INSTALLATION
LOG SET INSTALLATION
Installation of Brick or Stainless Steel / Black Enamel Panels must be completed before installing the log set.
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
Log Kit# 506-930 contains the following pieces:
A Rear Bottom Right Log
B Rear Top Left Log
C Right Top Cross Log
D Front Log Piece
E Left Top Cross Log
F Center Right Log
G Front Bottom Left Log
H Front Bottom Right Log
I Center Left Log
902-156 Lava Rocks
902-179 Vermiculite
946-669 Platinum Embers
(supplied w/packaged manual)
1) Carefully remove the logs from the packaging and unwrap them. The
logs are fragile, handle with care - do not force into position.
2) Spread vermiculite along the base of the fi rebox.
Vermiculite
I F
3) Place Log A on the rear log support pins with the fl at side to the back.
A
A
B
H
C
D
E
G
4) Place Log F on the right side of the burner, directly in front of Log A.
Position Log F so it fi ts into the pin on the burner as shown below.
F