Stack-On GC-8-RTA 4327-0707 - Manual (Page 2)

4327-0707
2 18
3. Assemble the optional storage shelf at this time. It will be
easier to align the holes without the top on.
Use the top set of holes in the side panels and assemble the
shelf with (4) machine screws and locking nuts. (See Figure 3)
4. Assemble the top panel (which has the
name plate). This will assemble the same
as the bottom panel.
With the front and back flanges on the
outside of the cabinet and the side flanges
on the inside of the cabinet, assemble with
(10) carriage bolts, lock washers and nylon
locking nuts. (See figure 4)
Now tighten all the fasteners in the cabinet
body. Do not over tighten.
5. The door can be assembled on the left or right. Depending on where you
are going to place your cabinet, you may want your door to open in a certain
direction. Review the section "Selecting a Location" and determine the
opening direction before assembling the door.
Align the door hinge holes with the cabinet holes. Assemble with (8) machine
screws and locking nuts. (See figure 5)
Center the door in the opening (from top to bottom) and tighten the screws.
Top panel
Figure 4
STA
CK-
ON
Figure 5
STA
CK-
ON
Door
Figure 3
Machine
screw
Shelf
Locking nut