Stack-On PSF-809-K 40040-0708 - Manual

HOME SECURITY SAFE
INSTRUCTIONS
IMPORTANT
Record your key number.
Keep keys and combination in a secure place away from children. Do not
store keys, external battery pack or this document in the safe.
Record your personal combination number.
Record your serial number located on the lower right corner of the door.
Key No.
Serial No.
Combination
GETTING STARTED
When you unpack your safe you will find the keys, batteries (4 - 1.5V, AA), and external battery pack packed in the foam packaging.
INSTALLING THE BATTERIES IN THE SAFE
Now that you have opened the door for the first time your next step is to install the batteries in the safe door. You have the choice of using the
batteries from the external battery pack you used to open the door or to purchase a second set of (4) 1.5V, AA alkaline batteries.
First unplug the external battery pack. Do not store the external battery pack in the safe. You may need the external battery pack to open the
safe at later time. Open the battery compartment on the back of the door and install the batteries. The blue display will read "ALREADY" and
then go into standby mode. Keep the door open and proceed to the next step of programming your own combination.
NOTE: Every time you change the batteries you will have to reset the date and time. Your personal combination will remain the same.
PROGRAMMING YOUR OWN COMBINATION
You are now ready to program your own combination. For security, you must reprogram your safe changing the preset factory combination.
Keep the door open the entire time you are programming your combination. Do not shut the door until you have tried the combination several
times and have written your combination on this form.
OPENING THE SAFE THE FIRST TIME
NOTE: An alternate way of opening the safe is to use the trouble key.
Please refer to the Trouble Key Section.
1. Install the (4) 1.5V, AA batteries in the external battery box.
2. Plug the battery pack into the left hole of the control panel. (Figure 1) The
blue display will read "ALREADY" and then the display will go into standby mode.
3. Press the " # " key. The display will turn blue and you will have 5 seconds to
enter the factory code.
4. Enter the factory combination ( 1 2 3 4 ) and press the " # " key to confirm
the combination. The blue display will read "OPEN". Turn the knob clockwise and
pull the door open. You will have 5 seconds to turn the knob otherwise you will
have to start over at step 3.
40040-0708 15
1
1. Press the " # " key and enter the the factory combination ( 1 2 3 4 ) followed by the " # " key to confirm the combination. The
display should read "OPEN".
2. Within 7 seconds press the " " key and then enter your own personal ( 4 - 8 ) digit combination followed by the " # " key to confirm
the combination. The display will read "INTO" and your personal combination has been programmed.
NOTE: If there is more than a 5 second interval between pressing the keys, the blue display will shut off and you will have to start over.
3. Check your new combination several times. Press the " # " key and enter your new combination numbers followed by the " # " key.
The display will read "OPEN". Turn the knob clockwise to retract the locking bolts.
4. You can reprogram a new combination by following step 1 and using your current combination instead of the factory combination.
5. If you have forgotten or lost your combination you will need to use the RESET BUTTON to reprogram a new combination. First, you
need to open your safe using the trouble key (please refer to the Trouble Key Section). After opening the door, press the RESET BUTTON
located on the back of the door and then follow steps 2 & 3 listed above.
1
External
battery pack
Knob Display in standby mode
WEEK
1
6
7 8 9 0
2 3 4 5