Stack-On PS-512 9123-0708 - Manual

ENTERING YOUR SECURITY CODE
To enter your own security code you will need to follow the steps listed below:
1. After installing the batteries, locate the small red button on the inside of the door near the hinge.
2. Press the red button and then release it, you will hear a beep. DO NOT SHUT THE DOOR UNTIL YOU HAVE
CONFIRMED THAT YOUR NEW SECURITY CODE HAS BEEN ENTERED CORRECTLY.
3. With the door open, enter your own personal security code, which can be 3-8 digits long, and confirm your
new code by pressing the " # " key on the electronic touch pad. Before you close the door, try the new security
code to make sure the lock releases the knob so you can turn it and retract the live action locking bolts.
If the code fails, go through steps 1-3 again. If the code works successfully, then you should lock the safe.
When you open the safe in the future enter the security code you have set followed by the " " key and turn
the knob.
If the incorrect security code is entered 3 times you will have an automatic lockout for 20 seconds before you can
try your code again.
If the incorrect security code is entered 3 additional times there will be a 5-minute lockout before the code can be
tried again.
IMPORTANT
Record the serial number from the tag on the back of the safe or the
tag on the inside of the lock cover plate on the front of the safe.
Record your combination number.
Keep keys in a secure place away from children.
For electronic safes - DO NOT STORE KEYS OR YOUR
COMBINATION INSIDE SAFE
Serial #:
Your Electronic Safe Combination
KEY SAFES
Insert key into slot and turn in a clockwise direction. Then pull the door open without removing the key.
If you lose your key please see the instructions at the end of this instruction sheet.
Home Security Safe
Installation Instructions
R ®
ELECTRONIC SAFES
When you first recieve your new electronic safe you will need to open the door with the key in order to
install the batteries. Batteries are included and are located inside the safe in the hardware bag.
To open the door with the key, first remove the small central panel from the front of the faceplate. Insert the key
and turn counterclockwise. Turn the knob to the right and open the door.
NOTE: This key has also been provided in case you lose or forget your security code or the batteries run low. If
you lose your key, you may purchase a replacement key by referencing the serial number located under the
removable central panel. See section at the bottom of this instruction regarding replacement keys.
Locate the batteries inside the safe. Open the battery compartment on the back of the door by pushing the tab
in the direction of the arrow and install the batteries.
9123-0708 12
1