Stack-On PSF-709 4616-0708 - Manual

SELECTING A LOCATION
Your Security Safe should be installed in an isolated, dry and secure area. For greater security
the safe must be fastened to a solid surface.
SECURING THE SAFE
Locate the (2) mounting hole locations on the inside bottom of the safe under the paper
stickers. It will be necessary to make a clearance hole through the safe insulation using a drill.
Drill holes through the insulation using the same diameter drill as the diameter of the
mounting hardware you are using. IMPORTANT: The fasteners you use must completely fill
the hole you drilled in the insulation. (figure 1) You must use the fasteners after you drill the
holes. Failure to do so will void the fire rating.
Through the clearance holes, mark the hole locations on the mounting surface. Drill the
appropriate diameter and depth of pilot holes depending on the type of hardware being used
and the type of mounting surface. Secure the safe with the fasteners. (figure 2)
NOTE: The safe needs to be upright and right side up or the locking mechanism won't work.
STACK-ON PRODUCTS CO., P.O. BOX 489, WAUCONDA, IL 60084
HOME SECURITY SAFE
INSTRUCTIONS
IMPORTANT
Record your key number.
Keep keys and combination in a secure place away from children.
Do not store spare keys or this document in the safe.
Record your serial number located on the lower right corner of the door.
Key No.
Serial No.
COMBINATION NUMBER
1st
4 times (R)
2nd
3 times (L)
3rd
2 time (R)
4th
1 time (L)
1. Turn the Dial clockwise passing the first combination number three times landing on the number the fourth time.
2. Now turn the Dial counterclockwise, passing the second combination number twice landing on the number on the third time around.
3. Now turn the Dial clockwise, passing the third combination number once - landing on the number on the second time around.
4. Turn the Dial counterclockwise until you reach the fourth combination number.
5. Place the key in the key slot and turn clockwise until it stops.
6. Pull the door open using the key.
Example: If the dial combination numbers were 70 - 50 - 30 - 10
1st
70 30
4 times 3 times twice once
2nd 3rd 4th
50 10
4616-0708
1 9
IMPORTANT
Keep your combination number and keys in a secure place, away from children. Keep this record of your serial number,
combination number and key number in a secure place separate from your safe. You will need the serial number as a reference
for obtaining a copy of your combination number or replacement keys.
To obtain a copy of your combination number and/or to order a replacement key set, follow the instructions on the attached form.
1
2
HOW TO OPEN
All numbers must be dialed exactly. If you pass a number,
you can not back up. You must start over. All numbers are
to be dialed to the Top Notch located on the top of the dial
ring. (the 12 o'clock position)
To lock the safe, close the door, turn the key counterclockwise until it stops and turn the dial several times.