Stack-On GCD-9216-5 4254-0707 - Manual

4254-0707
1 15
R
Home Security Cabinet
Installation Instructions
Model GCD-9216-5
®
Key #:
Serial #:
IMPORTANT:
Record the serial and key numbers from the back of the
cabinet. You will need the serial number information in
order to replace lost keys.
Do not store this document in your security cabinet.
Keep keys in a secure place away from children.
NOTE:
Assemble shelving and barrel rests before
mounting the cabinet to a wall or floor. Exterior access
is required for assembling these items. Review these
instructions prior to installation.
INSTALLATION OF BARREL RESTS AND SHELVES
THE BARREL RESTS AND SHELVES MUST BE INSTALLED BEFORE MOUNTING
THE CABINET TO A WALL AND BEFORE INSTALLING THE FOAM LINING.
Barrel rest assembly
Install the (4) 4-position barrel rests (B) to the sides and back of the cabinet as shown in
figure 2.
Use the top set of holes (C) on the inside center panel for mounting the barrel rest. The
inside center panel has clearance holes. There will be adequate access to assemble the
barrel rest using both hands.
1. Thread the screws into the pilot holes from the outside of the cabinet. (See figure 1)
2. Align the holes of the barrel rest over the tips of the screws and lightly press the barrel
rest into place. (See figure 1)
3. Now tighten the screws from the outside of the cabinet. Tighten each screw partially,
alternating from one screw to the other until they are both tight. Do not over tighten.
IMPORTANT: If you are going to use the shelves, install them before installing the foam
kit or mounting to a wall/floor. If you will be using the storage section for long gun
storage rather than shelving please see the section below and refer to figure 3.
Installation of Optional Shelving
Install each shelf (A) with (4) nuts and bolts. (See figure 2)
INSTALLATION OF OPTIONAL BARREL RESTS
Install the 2 remaining 4-position barrel rests (D) to the sides and the 7-position
barrel rest (E) to the back. (See figure 3)
Note: Use the lower set of holes on the center panel for mounting the barrel rest.
(REFER TO THE BARREL REST INSTRUCTIONS ABOVE FOR SPECIFIC
INSTALLATION INSTRUCTIONS)
7/16" wrench
Phillips screwdriver
Drill with
3/16" bit
Tools Required:
1
2
A
B
B C
3
E
D