Stack-On GSXW-836 40033-0708 - Manual

40033-0708
1 12
Home Security Safe
Installation Instructions
IMPORTANT
Record the serial number from the tag on the back of the safe or
from the tag on the front bottom corner of the safe.
Keep this record of your combination in a secure place away from
children. Do not store this document in the safe.
Do not move this safe using its handle. The handle should
only be used for opening and closing the door of the safe.
Removing the back panel on the door will void the fire rating.
SAFE TOP
VIEW
3
INSTALLATION OF SCOPE STAND-OFF
NOTE: The scope stand-off will function properly for
many combinations of guns with scopes.
Screw the scope stand-off into the pilot hole of the
barrel rest. (Figure 1)
HANDLE ASSEMBLY
Screw the 3 handle spokes into the hub and hand tighten. (Figure 2).
These spokes are located in the front foam packaging.
NOTE: Do not use this handle to move the safe.
SELECTING A LOCATION
Your safe should be installed in an isolated, dry and secure area.
For extra humidity control we recommend the use of a desiccant. Do not drill holes in the safe
for electrical dehumidifying devices. Do not drill through the insulation in the rear vent holes.
Do not mount the safe to a wall using these vent hole. This will void the fire rating.
For greater security the safe should be located in a corner and fastened to the floor. (Figure 3)
Place the safe in the desired location. Lift the carpeting up and locate the mounting hole bushings. These bushings are filled
with fire resistant caulking which must be drilled out before mounting the safe to the floor. Use a 3/8" diameter drill bit to drill out
this caulking. Continue to use this drill to mark the hole location on the floor. Move the safe away. Drill pilot holes in the floor
as follows: For a wood floor drill 5/16" diameter x 2-1/2" deep pilot holes. For a masonry floor drill 7/16" diameter x 2-1/2" deep
pilot holes for the anchors.
IMPORTANT: When you drill out the fire resistant caulking from the mounting hole bushings you must mount the safe
to the floor using the lag bolts and gasket washers. Failure to do so will void the fire rating and waterproof rating.
Reposition the safe and secure the safe with the lag bolts and gasket washers. (Figure 4) Replace the carpeting.
IMPORTANT: Because this safe is waterproof it will float. As the water level rises, the safe will begin to float and could
fall over causing personal injury.
The safe must be fastened to the floor using the lag bolts and gasket washer provided with this safe to insure
the waterproof rating. Failure to do so will void the waterprooof rating.
You must remove the safe from the skid and place the safe on the floor. Failure to do so will void the fire and
waterproof ratings.
SECURING THE SAFE
MODELS WITH OPTIONAL SHELVING
The shelving can be installed by locating the shelf clips to the desired locations and setting the shelf in place.
Do not store electronic media, computer disks, audio-visual media or photographic negatives in this safe. This
material will not survive the rated internal temperature of the safe. This material may be damaged or destroyed.
1
4
2
®
Combination #:
Serial #:
R