beautypg.com

Stack-On Total Defense Electronic Lock User Manual

Stack-On Furniture

background image

Key #

Your Electronic Safe Combination:

Keep keys and combination in a secure place away from

children. Do not store trouble key or this document in the safe.

• NOTE: Stack-On is not responsible for any cost incurred if
the safe is replaced due to a flood.

40253-1205

1

12

• Do not store electronic media, computer disks, audio-visual
media or photographic negatives in this safe. This material
will not survive the rated internal temperature of the safe. This
material may be damaged or destroyed.

Your safe should be installed in an isolated, dry and secure
area. For extra humidity control we recommend the use of a
desiccant. Do not drill holes in the safe for electrical
dehumidifying devices. Do not drill through the insulation in
the rear vent holes. Do not mount the safe to a wall using these
vent hole. This will void the fire rating. For greater security
the safe should be located in a corner and fastened to the floor.

You must first install the battery which is located in the front
protective styrofoam (See BATTERY REPLACEMANT below)

To open an electronic lock the first time, press the following
numbers/symbols on the electronic keypad in this order:
1, 5, 9, #. (These numbers are preset. You should change
the entry code as soon as possible after opening the safe to
insure proper security). After you have entered the factory
code, you will need to turn the handle clockwise to open
the door. You will have 5 seconds to turn the handle before
the locking mechanism is reactivated.

SELECTING A LOCATION

ELECTRONIC LOCK

Serial # / No série / # Serie :

• Removing the back panel on the door will void the fire rating.

• Warning: Keep your safe closed and locked at all times •
when not in use. Children could accidentally be locked inside
the safe.

• Do not move this safe using its handle. The handle
should only be used for opening and closing the door of
the safe.

• Record the serial number from the tag on the back of the
safe or from the tag on the front bottom corner of the safe.

®

Installation Instructions

WARNING

Tip Over Hazard

A child or adult can tip the safe and
be killed or seriously injured.
Failure to secure the safe as shown in
these instructions can result in death
or serious injury to children and adults.
Children should not play with or
around the safe at any time.

TD-E

Reposition the safe and secure the safe with the lag bolts and
gasket washers. Replace the carpeting.

IMPORTANT: When you drill out the fire resistant caulking
from the mounting hole bushings you must mount the safe to the
floor using the lag bolts and gasket washers. Failure to do so
will void the fire rating and waterproof rating.

Place the safe in the desired location. Lift the carpeting up and
locate the mounting hole bushings. These bushings are filled
with fire resistant caulking which must be drilled out before
mounting the safe to the floor. Use a 3/8" diameter drill bit to
drill out this caulking. Continue to use this drill to mark the
hole location on the floor. Move the safe away. Drill pilot holes
in the floor as follows: For a wood floor drill 5/16" diameter x
2-1/2" deep pilot holes. For a masonry floor drill 7/16"
diameter x 2-1/2" deep pilot holes for the anchors.

You must remove the safe from the skid and place the safe on the
floor. Failure to do so will void the fire and waterproof ratings.

The safe must be fastened to the floor using the lag bolts and
gasket washer provided with this safe to insure the waterproof
rating. Failure to do so will void the waterprooof rating.

WARNING: Because this safe is waterproof it will
float. As the water level rises, the safe will begin to float
and could fall over causing personal injury.

SECURING THE SAFE

Screw the 5 handle spokes into the hub and
hand tighten. These spokes are located in
the front foam packaging.
NOTE: Do not use this handle to move
the safe.

HANDLE ASSEMBLY

NOTE: You can store your Key #, Serial # and
Combination on Stack-On’s SECURE web site –
www.stack-on.com under Service.
Storing your Key # or Combination will provide instant
access to this important information should you ever lose
your keys or your combination.
Only you will have access to this information.