Schwank ThermoControl Plus 2 - Manual (Page 20)

- 20 -
5.4 COPY
The COPY button offers the opportunity to copy all parameters of a certain circuit or the complete
time program and insert it into the program of one or many other control circuits.
5.5 To securely save or reload all parameters:
The setup technician can save all operational parameters to memory. If the parameters are
changed unintentionally, the old parameters can easily be re-established using the data saved in
memory. It is also possible to reload the factory default settings.
To Save: Press CLR and +
simultaneously. The “SAVE”
symbol appears in the display.
Push DISP, the display will blink
while the parameters are saved.
Once saved the display
switches back to the main
menu.
To Load: Press CLR and SEL simultaneously, the
“LOAd” symbol appears in the display. Press the DISP
button and the parameters that were saved by the setup
technician, will reload. Switch from “LOAd” to
“FACt“,using the +/- button. If “FACt” appears in the
display push the DISP button to re-establish the factory
default parameters.
To copy parameters hold DISP (approx. 3 sec.,
chapter 5.2).
To copy time programs use the PR button (chapter.
4.4.1).
This example copies data from Zone 1 to Zone 2.
Push either the DISP (parameters) or PR (time
program) button
Zone 2 symbol start to blink. “COPY“ appears in the display
to indicate the copy mode. Push COPY to paste the Zone 1
data to Zone 2 (heating area 2).
The data of Zone 1 is now also located in Zone 2. The
Zone 2 symbol stops blinking to indicate the completion of
the copy process.
The data can continue to be copied to other Zones by
selecting Zone 3 to Zone 4 using the SEL button.
To finish copying the parameters press DISP button, or
press the PR button to finish copying time programs.