S&S Cycle Serial Delphi Style VFI (Variable Fuel Injection) Module and ProTune II Software - Manual (Page 6)

6
6- The VFI module uses an aluminum plug cover with three O-rings to protect the module’s serial port from the elements. Install the two smaller
O-rings on the screws and the larger O-ring in the port cover as shown in Picture 5. Then, install the port cover on the module using the two
screws provided.
NOTE: Included in this kit are components used to cover the serial port of the VFI module (o-rings, cover, and two screws). After the module is installed
and any required work with the ProTune II software is complete, install these components before it is put into service. This is required to protect the module
from the elements.
PROTUNE II SOFTWARE INSTALLATION
The ProTune II Software that is included with the VFI module allows the average performance enthusiast to install existing maps and modify them
to optimize the performance of a particular engine. Maps for some of the most common engine and exhaust combinations are provided on the CD
that comes with the VFI module. As additional maps become available from S&S, they may be downloaded from the S&S website at www.sscycle.
com. Once installed, a map may be optimized for the individual engine using a PC and S&S ProTune II software. Customized maps can also be saved
and reloaded allowing a switch between street and drag strip tuning quickly and easily.
You must have the following minimum PC specifications to install and run ProTune II:
• Microsoft® Windows® XP Service Pack 2 or later, Microsoft Windows Vista™, Microsoft Windows 7 or later operating system.
• 1.0 GHz or faster processor. Intel® Core™ Duo or faster/equivalent recommended.
• 128Mb System RAM, 256 Mb or more recommended
• 200Mb of free hard drive space.
• A desktop resolution of at least 1024x768 pixels. Higher desktop resolution is recommended for optimum use.
• A modern graphics system with 3D acceleration and 64 MB or greater on board RAM is required.
If you are new to the ProTune II program, you should load it on a computer and familiarize yourself with the screen and the controls before connecting
to the VFI module. All required information for the installation is explained below. For additional information on ProTune II, see the User Manual
installed with the software.
ATTENTION: Included on this installation CD is a link to the complete ProTune II manual. Print it out and keep it with you as you work with the software.
1- To install Pro Tune II for the first time or to update Pro-Tune II, perform the following:
a- Close all applications.
b- Insert the Pro Tune II installation CD into your CD or DVD drive. After a few moments, the ProTune II Setup Wizard should appear on your
screen and you can skip to step e. If the Setup Wizard does not appear automatically, proceed with steps c and d.
c- From the Start menu of your computer, select Run.
d- In the box marked Open: type D:\setup.exe and press Enter or click OK. Most PCs have the CD-ROM drive letter ‘D’. Replace this with the
appropriate letter if your CD drive is installed differently. If done correctly the ProTune II Setup Wizard will open.
Picture 5