RKI Instruments GX-2012 - Manual (Page 22)

18 • Downloading Data from an Instrument
If your computer does not have a built in infrared port, place the
instrument within an inch or two of the infrared port on the IrDA adapter
cable as shown in Figure 12 below, aligning the infrared port below the
RESET SILENCE button on the instrument with the infrared port on the
cable.
3. Press and hold the POWER
ENTER button on the instrument
until you hear a beep, then release
it. The instrument will begin its
power up sequence. If the L./B
MODE menu item in Maintenance
Mode is set to bH, LC, or LC bH,
press and release the POWER
ENTER button to continue the
power up sequence. If you do not
press a button for 20 seconds, the
instrument will automatically
continue. If a successful
connection between the instrument and the computer occurs, the
Connect light in the Download window turns green after a few seconds
and “Connection Successful.” displays in the Download area of the
Download window. The Windows
®
icon tray will indicate that a wireless
To Computer
USB Port
Infrared Port
GX-2012
Cable's Infrared Port
Figure 12: Aligning the Instrument with the Cable Infrared Receiver
Figure 13: Connection
Message