RKI Instruments GX-8000(PT0-098) - Manual (Page 34)

4 How to Use 4-8. Display/setting mode
GX-8000 - 34 -
Display an ID if it has been registered in advance. Also used to select an ID.
(1) Press the DISPLAY switch and select the ID display/selection from the display/setting mode menu.
The following screens are displayed in turn on the gas monitor.
(2) Press the ENTER switch to set or select an ID.
NOTE
• If you do not want to set or select an ID, press the DISPLAY switch to return to the display/setting
mode menu.
• On this gas monitor, either of the IDs from ST-ID000 to ST-ID255 has been registered, unless
otherwise specified.
• The data logger management program (option) is required to register or change an ID. Please contact
RIKEN KEIKI.
(3) Press either the ▲ or ▼ switch to select an ID.
Every time the ▲ or ▼ switch is pressed, the ID number increases or decreases (000-255).
(4) Press the ENTER switch.
(5) When END is displayed, the setting is completed.
The display/setting mode menu is displayed again.
(5) After completion, press the DISPLAY switch several times until it returns to the detection mode.