Retsch DM 400 - Manual (Page 9)

Safety instructions and use
9
2 Safety instructions and use
2.1 Requirements for the user
This Operating Manual is intended for persons commissioned with
the operation and monitoring of the DM400. The Operating Manual,
and in particular the safety instructions, should be heeded by all per-
sons working on or with the equipment. Furthermore the regulations
and provisions on accident prevention applicable at the application
site must be observed. The Operating Manual must always be kept
where the DM400 is used.
Persons with health disorders or who are under the influence of medi-
cation, drugs, alcohol or extreme tiredness must not operate the de-
vice.
The DM400 may only be operated by authorised persons and ser-
viced and repaired by trained specialists. Technically qualified per-
sonnel must conduct all maintenance, servicing and repair work!
Qualified personnel are people who have been authorised by persons
responsible for the safety of the system to execute the required activi-
ties and are able to recognise potential dangers and avoid them
based on their training, experience and instruction, as well as their
knowledge of relevant standards, regulations, accident prevention
regulations and operating conditions (definition of skilled personnel
according to IEC 364).
The instructions in this Manual should be followed in order to prevent
danger to the user.
Faults which can impair the safety of persons, the DM400 or other
material assets should be rectified immediately. The following instruc-
tions serve both personal safety of operating staff and the safety of
the described products as well as connected equipment: all servicing
and repair work may only be carried out by technically qualified per-
sonnel!
This Operating Manual is not a full technical description. It only de-
scribes information required for safe operation and maintenance of
serviceability.
Retsch has prepared and checked this Operating Manual very careful-
ly. However no liability can be assumed regarding completeness and
accuracy.
Subject to technical amendments.