Retsch DM 400 - Manual (Page 25)

Installation
25
3. After unscrewing the quick acting screws, pull the housing cover
(14) back by a few centimetres.
Then lift the housing cover up and out.
4. Two carrying lugs to attach the carrying straps are then visible.
5. Attach the carrying straps to a crane or other auxiliary equipment.
6. Now attach the carrying straps to the 2 carrying lugs provided.
7. With the help of the crane, position the disc mill in the desired
place. Take care while positioning that the device does not swing
when hanging on the crane.
8. Remove the carrying straps!
9. Place the housing cover (14) back on and screw tight.
4.4 Ambient conditions
WARNING!
Mains voltage!
- The device may only be used inside.
- The surrounding air must not contain any conductive
dust.