Quadrox QGuard Installation Manual - Manual (Page 21)

GuardNVR Installation Manual 21
Version 4.4 Series
Only the recommended screen resolutions are listed. For additional settings, click the
Advanced button on the Settings tab, click the Adapter tab, and then click List all
Modes. Select the resolution, colour level, and refresh rate you want.
For Vista users, please check the OS manual. The configuration differs slightly but
the idea behind the configuration stays the same.
2.4 GuardNVR in the network
2.4.1 Network overview
This chapter gives the schematic representation of the network camera and WebCCTV NVS
connections. To connect your network camera and NVS properly look at the following figure:
Connecting Network Camera and WebCCTV NVS Scheme Screen
To configure your network camera, please refer to the manufacturer’s manual
supplied with the network camera.
To add a network camera to GuardNVR (WebCCTV NVR in this scheme), refer to
the Camera Wizard chapter in the User manual.
Please note that a list of all supported cameras may be found in Appendix C.
Analogue cameras can also be connected directly to the GuardNVR when a digitizer
card is present on the GuardNVR.