Powertrax 3710 - Manual (Page 23)

23
piece of small wire (a paper clip works well) under the spring
and pop the bottom out. Push the pin out of the pin hole and
into the window hole. Repeat for the other three springs and
pins.
3. Move the right driver to the left, touching the left
driver.
4. Move the right spacer to the left, into the center of
the left driver. (Use the U-shaped wire tool.)
5. Rotate the left tire and both drivers until the C-Clip
installation recess in the teeth of the right driver is pointing
down.
6. Tap the right tire inward to release the C-Clip so
that it falls down, through the recess.
7. Rotate the left tire to rotate both drivers and allow
the C-Clip to drop out of the case.
8. Pull the right tire out about one inch.
9. Push the spacers into the centers of the drivers.
10. Remove the driver and spacer opposite the ring
gear flange first and then remove the second driver.
11. Remove the left C-Clip.
12. Remove the couplers.
Section 8: Technical Assistance
Section 9: Warranty Information
If you have general questions, please contact your local
dealer for assistance. If your questions are of a more technical
nature, you may call RICHMOND GEAR TechLine: 1-xxx-xxx-xxxx
for further information.
The Warranty is contained in the Vehicle Owner’s Man-
ual that is supplied with your new LOCK-RIGHT. Consult this
manual for complete warranty information.