Powertrax 3710 - Manual (Page 10)

10
Figure 2
Install shear pins and spacers
3. Place a spacer into the center of each driver, wide
end toward the teeth if not symmetrical (Figure 2).
4. Press a thrust washer (with grease added) onto the
back of each coupler.
5. Insert a small spring into each of the large springs
and add a little grease to the coils to hold them together. Set
them aside.
Assembly of the LOCK-RIGHT Parts into
the Differential Case
Summary of steps in this section:
1) Install Ring gear side coupler and washer
2) Install other coupler and washer
3) Install left C-Clip (C-Clips only)
4) Install left driver and spacer assembly
5) Install other driver (non C-Clip); or
6) Install other C-Clip (C-Clips only)