Powertrax 3710 - Manual (Page 13)

13
Figure 5
C-Clip axles—install C-Clip and right driver
b) Place the other driver assembly in the
differential case. Push it to the left, touching
the other driver (Figure 5).
c) Using the U-shaped wire between the
driver and coupler teeth, push its spacer
leftward into the center of the left driver to
help hold it temporarily in place.
d) Rotate both drivers with the left tire until
the C-Clip installation recess in the right
driver teeth is pointing out.
e) Tap the right tire inward, until the bottom
of the groove in the end of the axle shaft is
even with the surface of the coupler. Keep
the coupler seated in the case.
f) Slide the other C-Clip through the recess in
the teeth and into the groove in the axle
shaft end (Figure 5).
g) Pull the right tire out sharply to seat the
C-Clip.