Powertrax 3710 - Manual (Page 15)

15
Figure 6
Push pins into opposite driver
Push on the bottom coils to be sure that the spring snaps in and
is seated all the way. Rotate the drivers and do the same proce-
dure for each of the other three pins and springs.
4. Reach in through the recesses with your fingers and
be sure that the spacers are pushed outward onto the couplers.
5. Rotate the drivers so that the large recesses line up
with the pinion shaft holes in the differential case.
6. If an axle shaft thrust block is being used, push it
into the center of the assembly and line up the large hole with
the pinion shaft holes. If in the vehicle, push the right axle shaft
inward now, into the coupler splines, to move the block to the
center.
7. Carefully insert the pinion shaft into the hole and
guide it through the drivers, past the spacers (and through the
thrust block, if used). It should insert easily by hand. If not, tap
it in, being very careful not to get the inner end caught on some-
thing!