Powertrax 3710 - Manual (Page 12)

12
Figure 4
Non-C-Clip axles—Install drivers; C-Clip—left
4. Important! Be sure to have the spacers correctly
placed in the drivers before doing the following steps!
Pick up one of the driver-and-spacer assemblies. Ori-
ent its teeth toward the ring gear flange and hold it so that the
flats (if present) will clear the sides of the case. Place it on the
teeth of the coupler and press it into the grease (Figure 4). Reach
into the center and push the spacer down onto the coupler shoul-
der (and over the C-Clip, if so equipped).
5. For non-C-Clip axles only, repeat this step for the
other driver-and-spacer assembly (Figure 4), then proceed to
Section 3 on page 13.
6. For C-Clip axles only, follow the steps below to install
the second C-Clip and other driver.
a) Make a tool with a piece of stiff wire, such
as from a coat hanger. Bend it into a “U”
shape about four inches wide at the
bottom, with one-inch sides.