PIAA RS800 Halogen Shock Lamp - Manual (Page 7)

BULB CHANGE METHOD
The customers should not do
the installation work.
6.
•Never change the bulb when the lamp switch is turned on. Abnormal electric
discharge occurs, and electrification might result. It can be very dangerous.
(1) Remove two screws at the bottom
of the lamp.
screw
Lens unit
Water proofing cap
ceramic
connector
Tab
screw
(2) Raise the lens unit by lifting the bottom
of the lamp. Then, remove the tab at
the top of the lamp.
(4) Release the bulb spring and then
remove the halogen bulb.
(5) Replace the bulb and reassemble the lamp
by following the exact instructions in reverse.
※ Do not directly touch the bulbs while service of the lamps.
(3) Pull the ceramic connector straight
out from the bulb located in the lens unit.
Then remove the water-proof cap.
bulb