PIAA RS800 Halogen Shock Lamp - Manual (Page 3)

LAMP
INSTALLATION
2.
(1) For lamp installation, a hole with a diameter
of 14mm is required. Make necessary
preparation such as installation of lamp bracket.
(2) Using the Rubber cushion, flat washer, spring washer and nut install the lamp
to the car ensuring the PIAA logo reads right side up for proper mounting/draining.
• When using a commercially supplied lamp bracket, before removing the bolt
that is already installed on the car body, make sure that it is safe to do so.
• The lamp should be mounted in an area sufficient to support its size and weight.
Failure to do so may result in excess vibration leading to shorter bulb life and or
physical damage to the lamp or your vehicle.
• Do not attempt to install the lamp directly to any plastic part of the car body.
If the lamp needs to be installed on the plastic reinforcement materials should be
placed on both sides of the plastic part.
• When installing, make sure the lamp body, lens and rim are not touching the
bumper and other plastic parts. Such plastic parts might deform.
• The lamp installation surface should be flat.
Flat washer
Spring washer
Nut
• The lamp should be tightened to the degree that the lamp body cannot be
moved by hand.
Orientation of logo
Tightening torque : 30N-m
Flat washer
Spring washer
Nut
Rubber cushion
Rubber cushion