PIAA RS800 Halogen Shock Lamp - Manual (Page 4)

HARNESS
INSTALLATION
When connecting the wires on the harness, follow the
wiring diagram and the sequence below.
Before connecting any wires disconnect the negative (-) battery terminal.
Note: When running the wires through the engine compartment be sure to
Note: Holding the cord securely with pliers make sure the one-touch
connector is properly closed.
keep them securely away from moving parts such as the fan and the
throttle cable and away from hot parts such as the exhaust manifold.
Pull the connector for the relay harness switch into the car and connect to the
switch harness.
Identify the best location for the switch then attach the switch to the vehicle
using the double-sided adhesive tape (included).
As shown, fix the relay unit with the hexagonal bolt and the hexagonal nut so
that the cord comes to the bottom side.
Connect the switch power wire (white w/ red stripes) to your power source with
the supplied splicing connector.
Connect the lights to the wiring harness at this time.
Ground the (-) cord on the body side.
Connect the (+) cord (white) and the battery (+) terminal, and the black
(-) ground wire to the negative terminal of the battery.
Connect the (-) power cord (black) and the battery (-) terminal to the battery.
Use the harness band (included with P.N.34088) to fix the relay harness to the
car body side harness so that it will not come in contact with any movable
engine and or high temperature parts.
3.
10